924Board.org

Have you tried downloading the PET catalog from the Porsche website covering 1975-1979 porsche 924? Most parts are listed in there.
Chris

Hi everyone, its been a long while since I have posted here, I still have my 924 its off the road now, Been working on it here and there. I have also stepped up to a 84 928S, Enjoying all things Pors ...

I finally got mine mounted. The biggest pain was working from the inside the hatch, but it's there and it looks excellent...

Nice install looks like the same one that was on mine. just hope you ...

I got a rebuilded engine cheap, but it was not running right. I tried to adjust the valves, but 2 of the adjusters could not open enough clearance and 2 other were sitting in too deep. Probably mixed ...

I think its better to lose the badge then it is having someone cause damage to the car when they are trying to remove it. A gouge isnt too bad it could have been a lot worse such as pulled up/dented b ...

ok heres what happens.
start up the car and while its warming up to operating temp it will sometimes vibrate if the revs drop down abit doesnt matter if the clutch is depressed or not. (sign of worn ...

Hmmm I had the same type of vibe at the same rpm
though I tracked it down to being a busted coupler.

not to high jack the thread...

Joe what coupler are you talking about I seem to have this sa ...

cooling fan and blower fan are not running key is out of the ignition but that relay is warm to the touch. If I disconect the battery it becomes cool to the touch but hook up the battery again and tha ...

The cooling fan relay
I just went out and checked it again the relay is still warm to the touch
not enough to melt anything but u can feel it for sure.
Chris.

I noticed something today the fan relay heats up quite abit while driving bit hot to the touch is this normal?
Now when the car is off I find that same relay still warm to the touch I changed the old ...

You do know you must turn the adjuster 1 complete 360dg turn before it changes the clearance right ?

I have done mine cold too with no problem once the tappets were put back in the right order with the proper adjusters.
Chris

no change in engine sound? is the compressor turning on? is the belt slipping on the compressor?...When you turn on the heater do you get heat blowing out the vents? There is a possibilty that there i ...

Glue it on in the position you need it at.
I had to do that with mine.
Chris.

not sure how safe it is its, normally yes however if rework has been done to the head its possible are beloved non-inference engine has become interference type.
Thanks for the heads up.
So two ye ...