924Board.org

Anyone know how to refit the cam belt cover. I wrestled with it to remove it to change cam belt and fix stat housing leak.
Driving me crazy!!

Thanks bud. I'll take them apart and check as per thread.
Will let you know.

Hi guys, never seemed to work the switch on the drivers side controlling the passenger window!! Passenger switch works well. Any suggestions as I've been all over it with my multimeter and can't figur ...

Cheers. I have a Gunson gas tester which I use for the mot tests.
Thanks again.

csv okay. How do adjust the mixture from lean to rich? Clockwise turn??

Your emissions are too low IMHO, these things are best around 2 to 3%, I normally aim for 2.5, but it does vary car to car.
You think I have messed the cold idle as a result of low co adjustment? She ...

Thanks guys. Emission pass here is 4.5 CO and 1250 HC.
Yes need to invest on a cis tester.
Btw the idle screw is 6 full turns out from its seating point?? Too much?? Idle is around 950 hot.

Hi Guys, got the emissions done 1.0 and passed the MOT. Good for another year

Next morning she fired up but was very lumpy and struggled to idle at 950 until almost running temp. I had to hold th ...

Cheers Paul.
As I only need to do it once I think the 2 nails job will do. LOL

Nice one Stefan.
Cheers

Hi Stefan, do you need a special tensioner pulley wrench to tighten the belt. Mine looks like yours with the two holes as opposed to a tension "nut" shown in the Haynes manual?!

Yes the single line wear mark you can see on the middle of the belt. I assume it wasn't there when fitted, but I may replace it ne way.

http://i1108.photobucket.com/albums/h404/RobertN4/image_zpstiht5jdb.jpeg[/img]

Yeah can't wait!!
Cam belt has a mark all the way round as though it has been rubbing on the cover which I think may be occurring near the oil pump area as the cover is narrower there. ( just a thoug ...

Got the bad boy out!!!
Thanks for the advice. A slight manipulating done the trick. I thought I would have to start loosening other belts!!
Cheers.