924Board.org

yeah i was worried about that as well since it was NOS

Its still under a warranty and all so if they are bad... i will be contacting the company to get new ones sent...

I plan to pull the rail ...

I dont think the O-rings twisted or rolled... i lubed them up before i put them in and the Injectors are new (New.Old.Stock)

I still plan to pull them and check them and going to let them spary int ...

so what your saying is that if the fuel rail is not completly bolted down (the 4 bolts) that it will not close the injectors properly?

That does not seem to make sense...completly

I thought the ...

HELP!!!!!
Ok.. i am getting a lot of fuel in the oil and dont know where to look... the injectors are new... the o-rings are new.... the fuel pressure reg and diaphram are all new as well.... not sur ...

Im probably going to go the route od swapping in clutch parts for the Rubber.. so any suggestions on the right clutch pressure plate and such i need to replace the rubber damper would help...

i ...

so basically your saying i could eliminate the rubber and attach the flywheel and such (using a ford mustang (mid 80's) clutch kit non 5.0) and would replace that... then i just need to rebuild the T ...

According to the motor mount thing.. i should be feeling a vibration or knock on startup and shut down and a hard vibration at idle... i dont have any of these symptoms... its only at 3000+ RPM's

...

the motor mounts do not appear to have any issues. The motor has no play in it if i try to rock it by hand and barely moves on start up or under a load from flicking the throttle

Im starting to lea ...

I do know that USUALLY when a bearing goes bad its more of a whine

Also what is that rubber wheel disc thingy that bolts up to the flexplate? You know... the one that has the rubber center (massiv ...

Ok guys its been a while since i have been on here.

I have isolated the random death to a relay by my battary... and so far have been un able ot figure why it keeps tripping... still searching it. ...

well the car died on me again... and i gave the new relay a good knock and what not.. and it started again.

Does everyone else or anyone else have a relay sitting by their battary? Im still not su ...

well ill update.....

I had the car die on me several days ago and figured id give that relay by the battary a good knock.... and it fired right back up.... died again about three block... hit that ...

Would the ref sensors be an issue if the car is starting and firing.. and running just fine for days between random deaths?

Its possible... i wont rule it out and ill check it this weekend when i g ...

ok... where is the DME relay at again?

i thought it was in the fuse block, but i think some ghetto wireing was done and the DME for me might now be by my battary... unless that is normal and its ...

Well.. starter just died on me... and resulted in car being towed back to the apartment.

The starter i think was the issue with the hard starts.. the dying of the starter now solidifies my hunch on ...