924Board.org

small update !!!

The PO, for some reason thought it was wise to use some ducting often found in ponds and such to replace the bellows between the fuel dizzy and the turbo. This was giving a vacuum ...

It has been a while now, so lets give an update after more or less a year of driving around with the MSD unit. So far, it hasn't let me down and I can really recommend the conversion !!!

In my case ...

Hi all,

I have purchased a misc intercooler and I am looking for options to mount it. My goal is to make it look as stock as possible. There are plenty of examples where people chop the charge tube ...

Hi,

I actually have a bracket for the ditc that I do not use (MSD bladiebla)...

Do you need the bracket or just a photo?

Jasper

Ok, some new additions:

- Three spoke steering wheel wrapped with fresh new leather
- New leather gear gaiter
- New Porsche decals
- New window scrappers

and......

Fitted a Porsche CDR-220 ...

Vid...

http://youtu.be/2h6LkANnQds

http://youtu.be/2h6LkANnQds

So,

Little update, mounted some rear spacers (23mm) and removed the glue residue from the old decals. Must say, the clean look really does look nice...

About the steering wheel, I am trying to h ...

Thanks for the nice words !!!

Runs like a charm. In the meantime I did tweak the ignition map so the boost region is more conservative, eliminated vacuum advance and use a slightly modified DITC fu ...

Hi All,

As some of you read before, there is one 931 running on MSD's 6AL2 ignition. Since that endavour, I polished the rims and send the car of to the paint shop to repaint some panels.

The r ...

That for the suggestions, I tuned the map so its a bit more conservative. Also, my DIY FPR/switch set-up is quite handy if one wants to set the initial AFR. Now its running like a charm, a bit on the ...

Nice job Jasper.

ITB = independent throttle bodies. Det cans = DIY stethoscope. Bit of hose held to engine, other end inserted into a tin can, bottle neck with open end, etc. Difficult to use whil ...

It seems OK and I wouldn't advance it further at WOT due to not having an intercooler (my car has). Perhaps to be sure the engine is not knocking, you should fabricate det cans..

As for idle, my ca ...

I ended up showing you how to install the MSD 6530 and get the car running. Now I will show the steps I’ve made to make the car drivable. But before I do that, I want to address a problem I described ...

Hi guys,

Thanks for the kind remarks. I really hope this helps people that are struggling with DITC problems and want to convert to something more reliable and modern. I must admit, it all went eas ...