924Board.org

TYPE111

Anyone put a cycle type bottle holder using the rubber plugs with a threaded end (rawlplug??) into their car on the passenger side of the transmission tunnel?

Trying to make the car a bit more user friendly and was hoping by drilling two holes into the centre tunnel I wasn't risking puncturing anything.
_________________
Trust, Then Verify

morghen · Joined: 21 Jan 2005 Posts: 9102 Location: Romania

I would drill into the center console side instead.
_________________
Supercharger and EFI kits
https://www.the924.com

fiat22turbo · Joined: 18 Jan 2006 Posts: 4040 Location: Portland, OR

A PO did that on my 951. Looks like crap.

Personally, I'd make something that folds out from under the dash next to the console. If you look around there are some neat pieces that are made to hide under the dash and slide out that should be adaptable to our cars.

Or use the folding cup holder solution from only944.com

As long as you verify there aren't any fuel, brake or electrical lines in the area before you drill, it will work.
_________________
Stefan
1979 924 Carrera GTS (clone-ish)
1988 944 Turbo S (Silver Rose)

Joes924Racer · Posted: Thu Jul 31, 2014 3:34 am Post subject:

I almost did it ,right behind the shifter on top of the tunnel. A double cup holder no less. Go for it.
_________________
1979 porsche 924 Na
1980 porsche Turbo 931GT Replica
Have u ever driven a turbo.

D Hook · Joined: 02 Nov 2002 Posts: 3158 Location: Omaha, NE

Get one of these.

Wire it up and push the button; instant cup holder.
_________________
'80 924 n/a SOLD