Show full size 924Board.org
Discussion Forum of 924.org
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 
 Technical FAQ924 FAQ (Technical)   Technical924 Technical Section   Jump to 924.org924.org   Jump to PCA 924 Registry924 Registry

924S Tires and Rim question

 
Post new topic   Reply to topic    924Board.org Forum Index -> 924S Discussions
View previous topic :: View next topic  
Author Message
Schreiberdeutsch  



Joined: 24 Aug 2006
Posts: 42
Location: Macon Georgia

PostPosted: Sat Sep 30, 2006 1:25 pm    Post subject: 924S Tires and Rim question Reply with quote

I currently on my 924S have 195/65 R 15 tires, and the Telephone dial rims i think ive heard them referred to as Turbo S Dials too im not sure but what not can i possibly put something like 225/40 R15s on these rims without them hitting the fenders on the rear?

thank you in advance

Ryan
_________________
87 924S (Wrecked)
$5,000 worth of work done to engine

1995 Mustang GT 5.0
Back to top
View user's profile Send private message
gohim  



Joined: 02 Nov 2002
Posts: 4459
Location: Rialto, CA

PostPosted: Sun Oct 01, 2006 5:18 am    Post subject: Reply with quote

Your 924S came with 15" X 6" phone dial wheels.

These are not the same width or diameter as the phone dials that came on the 951 Turbo S.

IMHO 225s are going to be too wide to fit and work properly on 6" wide wheels.
Back to top
View user's profile Send private message Send e-mail
Schreiberdeutsch  



Joined: 24 Aug 2006
Posts: 42
Location: Macon Georgia

PostPosted: Mon Oct 02, 2006 3:42 pm    Post subject: Reply with quote

thanks for enlightening me....

what is the widest tire i can put on these rims...

thanks again!
_________________
87 924S (Wrecked)
$5,000 worth of work done to engine

1995 Mustang GT 5.0
Back to top
View user's profile Send private message
Lizard  



Joined: 03 Nov 2002
Posts: 9364
Location: Abbotsford BC. Canada

PostPosted: Tue Oct 03, 2006 3:51 am    Post subject: Reply with quote

I have run 225 on 16x6 rims without an issue, just a matter of getting the correct offset.
but 205 is what alot run on 6" rims
_________________
3 928s,
Back to top
View user's profile Send private message Send e-mail
gohim  



Joined: 02 Nov 2002
Posts: 4459
Location: Rialto, CA

PostPosted: Tue Oct 03, 2006 5:47 am    Post subject: Reply with quote

There is an maximum tire width acceptable for each wheel width calculated as a percentage of the tire width.

When the wheel width is below a specific percentage or above the specific of the width of the tire being used, the tire may not make contact properly with the ground (uneven), or the tire sidewalls may not be properly supported by the wheel.

Wheel width to tire width can also affect the specification for maximum tire loading.

To find out the recommended maximum width on a specific width wheel, and to get specific tire recommendations for specific uses, try dropping into some of the Websites of the larger mailorder tire companies.

A 225/40 is much smaller in diameter than the original 195/65 width tires that the 924S came with. You are going to have a HUGE speedometer error if you install this size of tire.

You would probably be (1) tire width too wide with 225. I think 215 are acceptable according to general tire fitting spec. rules.
Back to top
View user's profile Send private message Send e-mail
Display posts from previous:   
Post new topic   Reply to topic    924Board.org Forum Index -> 924S Discussions All times are GMT + 10 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group