Show full size 924Board.org
Discussion Forum of 924.org
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 
 Technical FAQ924 FAQ (Technical)   Technical924 Technical Section   Jump to 924.org924.org   Jump to PCA 924 Registry924 Registry

Waste Gate Diaphragm Lube

 
Post new topic   Reply to topic    924Board.org Forum Index -> General Discussions
View previous topic :: View next topic  
Author Message
stevekat  



Joined: 19 Jan 2008
Posts: 719
Location: Los Angeles, CA
PostPosted: Tue Nov 24, 2009 12:29 pm    Post subject: Waste Gate Diaphragm Lube Reply with quote
I haven't rebuilt a waste gate in some years. Last time was when I obtained the parts from Peter Dawes back in the day.

I have a vague recollection that his instructions were to spray some graphite powder in the chamber...

Does this sound right? Also, does it matter whether one does the vent or pressure side, or both?
_________________
"Never get out of the boat. Absolutely goddamn right. Unless you are goin' all the way."

Gone to new home: '81 924T, US version, CGT Intercooler, UTCIS-PT, Euro DITC, Greddy Trust MBC, Forged Fuchs Flat Dish 6's, Factory Recaro's.
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    924Board.org Forum Index -> General Discussions All times are GMT + 10 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group