| View previous topic :: View next topic |
| Author |
Message |
Rasta Monsta

Joined: 12 Jul 2006 Posts: 11733 Location: PacNW
|
Posted: Mon May 30, 2016 8:18 am Post subject: Steering Rack Ground Strap |
|
|
Trying to figure out the above.
If there's anyone who could conveniently snap a pic, I'd be grateful. _________________ Toofah King Bad
- WeiBe (1987 924S 2.5t) - 931 S3
|
|
| Back to top |
|
 |
brian19600

Joined: 28 Oct 2013 Posts: 375 Location: NJ/CT
|
Posted: Mon May 30, 2016 10:50 pm Post subject: |
|
|
I just went out, climbed under the car and looked and I didn't see any ground strap. Do you have the PET page that would show it? _________________ 78 924 |
|
| Back to top |
|
 |
Kenodog

Joined: 25 Jun 2003 Posts: 2669 Location: Vancouver,B.C.
|
Posted: Tue May 31, 2016 3:33 am Post subject: |
|
|
Never seen one. The assembly is bolted to the cross member which is bolted to the chassis. Wouldnt really need a ground.....
Me.....Leigh _________________ 1979 Euro 931, Olive
1981 931, Sabine
1991 Ford Ranger XLT 4x4, Ricky
1996 Ford E-350 ex-FedEx Van
2014 Mazda CX-5 (Kinderwagon)
2019 KTM 790 Adventure
2024 KLX300
2024 KLX140 |
|
| Back to top |
|
 |
ideola

Joined: 01 Oct 2004 Posts: 15550 Location: Spring Lake MI
|
Posted: Tue May 31, 2016 3:56 am Post subject: |
|
|
I have seen ground straps on some cars from the block to the cross member. From memory, I seem to recall it going from one of the bolts by the A/C / Alternator bracket, and then grounding to the upper LHS bold where the steering rack mounts to the cross member. _________________ erstwhile owner of just about every 924 variant ever made |
|
| Back to top |
|
 |
Rasta Monsta

Joined: 12 Jul 2006 Posts: 11733 Location: PacNW
|
Posted: Tue May 31, 2016 12:18 pm Post subject: |
|
|
Thanks for the replies. Fwiw, my car did have a ground strap from an oil pan bolt to the x member. _________________ Toofah King Bad
- WeiBe (1987 924S 2.5t) - 931 S3
|
|
| Back to top |
|
 |
hdrider19
Joined: 03 May 2016 Posts: 193 Location: Catawissa Missouri(40 mi sw of St Louis)
|
Posted: Sun Jun 12, 2016 5:29 am Post subject: |
|
|
| About to drop engine out of my 87 24S. There is a small ground wire on the clamp bolt for the pressure hose straight down from steering shaft. It runs over the back side of pressure hose and down to cross member about 3 inches to the left of lower drivers side rack mount bolt. It is held to x member with a Phillips screw. Still don't have photobucket set up. Sorry. Hope this helps. Paul |
|
| Back to top |
|
 |
hdrider19
Joined: 03 May 2016 Posts: 193 Location: Catawissa Missouri(40 mi sw of St Louis)
|
Posted: Mon Jun 13, 2016 11:00 am Post subject: |
|
|
| I just checked my 84 944 parts car. It also has this ground wire in the same location I described above. |
|
| Back to top |
|
 |
hdrider19
Joined: 03 May 2016 Posts: 193 Location: Catawissa Missouri(40 mi sw of St Louis)
|
Posted: Mon Aug 01, 2016 12:01 pm Post subject: |
|
|
Sorry it took so long to post this. Had to give up on photobucket. I hope it helps. _________________ 87 924S |
|
| Back to top |
|
 |
|